You are not connected. Please login or register

Phason Support Forum » Frequently asked questions (FAQs) » Single stage controls »  Fan motor doesn't run (MTC-3C, MTC-4C)

Fan motor doesn't run (MTC-3C, MTC-4C)

Go down  Message [Page 1 of 1]

  1. Reset the thermal cutout on the fan motor and allow the motor to cool.
  2. Check that the wiring is done according to the user manual.
  3. Use a test light or voltmeter to test the power at the control.
  4. Replace the fuse. If the fuse blows immediately, a problem exists with the wiring or the fan motor. If the fuse blows after a delay (minutes, days, or weeks), the load is exceeding the current rating of the control.

View user profile

Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum