You are not connected. Please login or register

Phason Support Forum » Frequently asked questions (FAQs) » All controls » Relay testing

Relay testing

Go down  Message [Page 1 of 1]

1 Relay testing on 2013-01-09, 3:31 pm

To test if a relay is working, turn the power off to the load and disconnect both wires from the relay terminal. Insert an ohm-meter across the relay terminals and use the control's manual override to turn the relay on and off. When on, the meter will show a short or zero ohms. When off, the meter will show 'OL' for overlimit or a similar code, depending on the meter.

View user profile

Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum